Made a tracker box for the zombicide tracker pegs.

The tracker board might be a bit tight for the pegs, but I fixed it with a file to make the holes bigger after I printed it.
There might be a better scale, but I'm not sure what :)
It fits 12 tracker boards into the box.

Print the lid with the top down.
Lid might also be a bit tight fit on the box, but I fixed that with a file on the corners of the actual box. It also helps to take the lid on and off a couple of times.
If you want two colors like I did pause at layer nr. 5 on the lid and switch filament.