I was looking for a cool stand for my xbox controller, and I found this one made by ckflyer. 

The model itself is very nice, except it had some minor problems, so I decided to fix them.

• As the images show, now printing it won't require any support;
• Improved overall adhesion of the model;
• Fixed the model's mesh, which had some artifacts on the bottom side.

One more thing I changed was just making the logo itself, printable in parts, rather than changing filament mid-print. They should just snap in hold nicely, (use glue if needed).

Print instructions

• No support needed
• Print in the orientation as showed on images