This is a remix of https://www.thingiverse.com/thing:4637458
Added two 15mm magnets for fridge placement.
Print it horizontally, "breast" pointing up :0 so the supports to be inside the body where will not bee seen after, so the "breast not to have supports" :))
The file is oriented already horizontally.

P.S.
Supports will be fine inside the magnet holes on the bottom.

1. Make sure the magnets to be strong.
2. NOTE! After printing and glueing the magnets, COVER THE BACK WITH SOME NON-SLIPPERY MATERIAL. I have used thin layer of rubber cement. So it will be not slipping down on the fridge door and will leave no mark.
   Have fun !

Qidi X-plus

No

Yes

0.2

25%