Look, this is the housing and ball joint of the improved feeder/indicator for the Elegoo Centauri Carbon!

This design has four variants, which can adapt to the feeder installation design of Elegoo's batch 1 and batch 3, and support two different sizes of Bowden tube connectors, which are suitable for PC4-M6 or PC4-M10 pneumatic connectors/couplings of PTFE tubes

The model is designed with a ball-joint, which allows the feeder to achieve various angles in all three-dimensional directions. This enables it to direct the consumables from the desired storage location smoothly, without bending or tangling the materials! You no longer need to move your printer and consumable storage containers. Simply print and enjoy the customization freedom your setup deserves!

The rods of the circuit/gearbox are very small, just like the characteristics of 3D printing, and they may break, so be careful when installing parts. The bearings should be installed naturally at the correct height, but this may vary depending on the humidity, expansion, and warping of the consumables you need during the printing process. If the consumables don't pass through the box smoothly, then the problem lies here. The grooves in the bearings need to be perfectly aligned to form an open channel for the consumables.

Rating and comment suggestions:

Please take a moment to write down the reasons why you chose this rating, especially if it's lower than 5 stars. This will not only help any creators improve their designs to better serve your future use, but also help other consumers make their own judgments and modifications when necessary. A single rating lower than 5 stars won't help anyone, because no one knows why you're not satisfied or where the shortcomings lie. It might even help you better understand your printer and how to use it, because the problem might often lie in the preparations you've made or failed to make.