AI helped me make this. AI bad, yes, I know. But rather than upload the original sloppily-generated result, I took hours to clean up the file and make it look good. This is a decoration intended to look like one of those cast-iron pieces. A simple matte black and matte clear coat is pretty convincing but with some patience and skill you could make it look like real iron, especially if you sand down or fill in the layer lines.

There are 2 versions: one with the original cane and one with holes for a 1/4" wooden dowel. The cane turned out awful the first time so I figured a wooden dowel would be sturdier. And it is! I think it looks pretty good.

The version without the cane is QUITE LARGE and likely won't fit on most printers. Source a smaller rod or take your chances with the built-in cane when making it sizing it down.

I printed the base at 40% and the body at 5% infill to make it bottom-heavy. Because of its size, I actually recommend more perimeters/shells to make it slightly more rebust.

Minimal tree supports needed.