Watch:

These flashing goggles use an adaptation of my "all-in-one printing" iris box.http://www.thingiverse.com/thing:1817180) And this iris box is an adaptation of Emmett's pre-assembled iris box.http://www.thingiverse.com/thing:1811143)。左右“眼球”卡入护目镜中，一个3D打印的弹簧将它们保持在打开状态。一段不显眼的鱼线用于驱动眨眼。或者你也可以省略弹簧和鱼线，直接手动操作每个虹膜。此外，你可以添加“镜片”来提升外观

Print settings

Printing brand:

MakerGear

Printers:

M2

Raft:

None

Support:

None

Resolution:

0.2mm

Fill in:

20%

Note:

Print one normal eyeball and one mirror eyeball for the left and right sides. Also print the spring and the goggles themselves. When printing the goggles, the speed should be slower, and it may be hotter than usual to ensure that the layer of the little finger that grasps the eyeball is fully fused

Note: Please also refer to:http://www.thingiverse.com/thing:1817180Get more tips on how to successfully print an eyeball

Post-processing

In addition to the 3D-printed parts, you will also need an elastic band about 12 inches long and 3/8 inches wide

The operating directions of the left and right irises are different. When the irises are opened and the small actuator tags are installed at the top of the goggles, they should open when the tags move outside the goggles. Correspondingly, each eyeball should be fitted into place. Please be very careful, because if the small fingers on the goggles are bent too much, they may break.

Next, insert the spring into the label as shown in the picture. The iris should automatically pop open. If they want to close, please replace the eyeball. Thread one end of the fishing line through the hole on the right side of the spring, then down through the hole on the right side of the goggles, and up through the hole on the left side of the goggles. Finally, tie it to the left side of the spring. Finally, thread the elastic band through the grooves on the side of the goggles.

Put on the goggles. Pass your thumb through the large loop of the fishing line and gently pull it down to blink. Both sides must be pulled at the same time, otherwise the spring will get stuck

Optional lenses: Cut two 1.75-inch diameter discs from colored acrylic board

Update:For more assembly instructions, please check out the excellent video posted by NeatherBot on his iris goggles making process:http://www.thingiverse.com/make:263657

Category: Clothing