This is a remix of an existing phone stand but with usefull holes. 

The hole for the charger is based on my Type-C charger + a little bit of extra room and in the end measures: 18mm x 6.5mm (aprox. 0,709 inches x 0,256 inches)

I made 2 distinct phone plates, both with the new holes for charger and speaker.

• One with just the new holes.
• One with an easy-print division. I removed the gear from the back and made a dent for a easier glueing process.

I made the “easy-print” because in this way I don't need supports using my resin printer. To do so i cut out the gear in the back and created a dent so i can glue it back after the print. I made sure to stretch the gear base to fit the dent and still have the same measures as before.

Due to shrinkage or material factors, the gear could need some sanding.