The second generation has now been launched:https://makerworld.com/en/models/1885742-ice-scoop-gen-2#profileId-2019642

I designed this very practical tool to scoop the ice cubes made by my refrigerator and put them in iced coffee or water bottles

I suggest using less infill, as there are many voids in the handle. If you plan to use this spoon to crush large ice cubes, then I recommend using the infill rate you deem appropriate. Maybe 25%? Print it upright with supports. The print will consume about 65 grams of filament.

I just started learning modeling, and I've put a lot of time into it. I hope you'll enjoy it!