Summary

50kg Load Cell Bracket, reworked with 3Pin JST XH connector to protect against flimsy cables.

Typical Usage
As with the original original bracket, insert load cell into the bracket and feed the cables through to the bay that will hold the JST connector. Cut the cables to length and solder to connector.

In case it helps, connect:

1. Pin 1 to the positive strain (top of potential divider)
2. Pin 2 as the centre and
3. Pin 3 as the negative strain (bottom of potential divider)

Glue the JST connector to the bracket.

Place the spacer on top of the load cell, taking care not to trap any of the cables. You may need to glue this in place if you are not mounting this to the underside of a unit. Screw the holder in place and enjoy!