I originally printed this for my Aquila and it fitted and worked good, but I found it a little bit wobbly when inserting and removing the SD card. Plus the bottom screw hole on the base did not match up. So I matched up the screw hole for the Aquila added an extra top support just to make it a little more rigid. I also enlarged the hole in the card slot holder to make it easier to insert the bolt. The ribbon insert on these type of adaptors tend to slide out easily from the card port. I found that placing a little bit of blue painter's tape on top of the insert gave it enough extra friction to stay in place.

Voxelab Aquila

No

Yes

0.2

20%