This adapter lets you attach a Seek Compact thermal camera to any tripod that has a standard ¼"-20 UNC thread.

I printed this in PLA, but any material is likely to work.  Since the model includes a printable screw thread, it's recommended to use an 0.4mm nozzle or smaller, and a small layer height.

To install the camera, hold the camera at about a 30-degree angle to the horizontal with the USB connector on top, slide the rounded end sideways into the corresponding section of the adapter, and then rotate to horizontal.  In my testing, the camera remained in place even with the adapter upside-down, but you may wish to secure the camera with some tape just to be safe.