I purchased these allen sockets at harbor freight:

https://www.harborfreight.com/38-in-drive-sae-long-reach-ball-head-hex-socket-set-7-pc-67885.html

https://www.harborfreight.com/38-in-drive-metric-long-reach-ball-head-hex-socket-set-7-pc-67888.html

I wanted a way to store them so they were organized and i could readily find the correct one when I needed it. I designed these holders to do just that! They can lay in a drawer (the way I intend to use them) or can be mounted to a wall with the provided screw holes. I also added some pockets for magnets. There are 4 pockets for 1/2" x 1/8" neodymium magnets on the bottom. This way, if they are in a metal drawer, they will be less likely to slide around. There are also 2 small pockets per socket that can accept a 1/4" x 1/8" neodymium magnet to help hold the sockets in place. This should keep them in place when mounted vertically and also help keep them from popping out of position when used in a drawer that is being opened and shut rapidly. This was designed in inches, so if it shows up small in your slicing software, you need to multiply the scale by 25.4 to convert mms to inches. I hope you can get some use out of this and POST THOSE MAKES!

FYI: The holders in the image did not have the magnet recesses for the smaller magnets, as they were an addition that was made later.

Creality

CR-10S

No

Yes

.2

30