Modular egg holder

Modular egg holder for your enjoyment. Each segment is 9.2 cm deep and holds 2 eggs. You need to print left and right segments and then as many middle elements as you desire. Then put it all together without any glue or anything. The smallest setup can hold 4 eggs - just print just left and right segment (in fact you can print just one segment if needed and ti should be stable, but you will get ugly connector sticking out of the shape). Left and right segments' width is 4,8 cm. Middle one is 5 cm wide. Each segment is 2 cm tall.

Print without any raft, nor support. Just ensure it's printed upside down. You most likely can set infill to 0% (still, that that's won't make much difference as there's not that much to fill). Resolution 0.2.

Note this holder is designed to be lightweight and rigid enough to hold the eggs etc and not bend BUT it is not designed to be carried, esp. with eggs loaded. The longer your holder, the higher chance it will simply bend if you try lift it up by holding sides only. So to safely carry your eggs in it you may need to provide at least one additional support (in the middle i.e. 3rd hand :).