Show your Batman pride with this Batman phone stand! This two piece phone stand is very easy to print, because there aren't any supports or bridges to worry about! I printed this (with PLA) with these settings: Speed: 40 mm/sec Infill: 20%, honeycomb pattern Layers: 0.3 mm each, 0.4 mm for first Bridging or supports: None! Filament settings will vary by filament. I use Inland's red and yellow PLA filament. Here are the settings I used: Temperature: 220 C Bed temperature: 57 C Post-printing: My printer can't print very high quality, so I had to use a finishing tool to smooth out edges and make some of the holes a little bigger. I bought a really cheap one, but does the job well: http://www.modifi3d.co.uk/ ***The phone used for this print was an iPhone 6, so I don't know if larger phones can fit. If they don't (which they probably won't), just scale the file larger, maybe 105%.