SummaryThis tool storage system utilizes the vacant sides of the printer. As shown, i have my jewelers tool set on the system. I have used a dovetail railing system at the top to join the pieces together. I used a little hot glue to secure them to the top. The upper pieces have the male dovetails that lock into the female dovetail rails along the top. The lower pieces connect with the pole sliding through the bottom of the upper pieces. You can glue these together if you would like, but they are pretty secure. Right now, i do not have mine glued to the sides of the printer. However, i would recommend placing a small amount of glue behind each pole to secure it to the printer. Double sided tape should work too. Please let me know what you think. I am always looking for good feedback. thanks and enjoy!Print SettingsPrinter Brand: UltimakerPrinter: Ultimaker 2Rafts: Doesn't MatterSupports: YesResolution: 0.6Infill: 55Notes: When i design something for my Ultimaker 2 i try not to alter the footprint. So i noticed the sides of the printer are not being used. This is where my design comes in. This tool storage utilizes the vacant sides of the machine. Right now they are holding a jeweler's tool set.Post-Printingjust needs a little bit of cleanup. How I Designed ThisI try not to alter the footprint of my printer when i design. and i needed a place to store my tools in a cool way!