The model from JamesThePrinter is incredible. After giving this to a friend as a gift, they asked if they could get one for their daughter that held more game cartridges. After a bit of tinkering, it seemed that it was possible to double the slots. So, that is what we have here. The same principle as the original just with more slots.

Both a Logo and No Logo Profile are available.

Assembly

You will need 1 x 608 bearing. These are the ones I used. They push fit perfectly on my P1S.

1. Push-fit a 608 bearing into the center opening in the base.
2. Put a dab of glue on the spring and insert the tab end into the opening on the inner base circle.
3. Insert the top into the base aligning the spindle with the bearing opening in the center.

Buy the original designer a coffee!