My second hueforge creation have fun with it. I only used 4 colors. Sunlu filament and for the white i used ellegoo rapid pla. you can always use other branche of filament. you  can scale it, not the z-axis.

project: wolferine.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 241.8x241.8mm in size

 You may print at higher layer heights below the Min Depth of 0.48mm

 The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:

 PLA PolyLite Black Transmission Distance: 0.3

 PLA+ Sunlu Red Transmission Distance: 6

 PLA+ Sunlu Pure Yellow Transmission Distance: 5

 PLA PolyLite White Transmission Distance: 5

 PLA+ Sunlu White Transmission Distance: 5

This print uses 5 unique filaments

Swap Instructions:

 Start with Black

 At layer #8 (0.72mm) swap to Red

 At layer #9 (0.8mm) swap to Pure Yellow

 At layer #10 (0.88mm) swap to Red

 At layer #11 (0.96mm) swap to Pure Yellow

 At layer #14 (1.2mm) swap to White

 At layer #18 (1.52mm) swap to Pure Yellow

 At layer #23 (1.92mm) swap to White for the rest.