Don't adjust the size in the slicer!! The layers won't display correctly.

Don't change the size, otherwise, it will lead to color change errors, which will affect the entire print.

Use my print configuration file, otherwise you won't be able to get the desired results.

It can be safely printed on any printer without the need for AMS.

I hope you like it. If you want to support me, please give it a thumbs-up and leave a five-star rating. Thank you!

Print with a 100% infill rate, a layer height of 0.08 mm, and a base layer of 0.16 mm

The size of the model is 180x180mm.

You can print with a higher layer height at a minimum depth of less than 0.48mm.

The maximum depth is 2.2mm, and the actual depth is 2mm.

The filament used:

Matte charcoal transmission distance: 0.1

Basic silver transmission distance: 0.7

Matte ivory white, transmission distance: 1.7

Matte scarlet transmission distance: 1.8

Basic yellow transmission distance: 5

This print uses 5 kinds of consumables

Exchange instructions:

Starting from charcoal color

Change to silver on layer #9 (0.8mm)

Change to ivory white at layer #12 (1.04mm)

Change to charcoal color on layer #14 (1.2mm)

Switch to scarlet red at layer #15 (1.28mm)

Switch to yellow at layer #20 (1.68mm)

On layer #22 (1.84mm), change the color to ivory white to complete the rest of the design.