Project: Goblin Killer, High Elf Archer.hfp
With a layer height of 0.08mm and a 100% infill rate, the thickness of the base layer is 0.16mm.

The model size is 111.69x170mm.
You can print at a higher floor height with a minimum depth of less than 0.48mm.
The maximum depth is 2.2mm, and the actual depth is 2.2mm.

Consumables used:
BambuLab Basic Black PLA, transmission distance: 0.6
BambuLab Basic Red PLA, transmission distance: 5
BambuLab basic brown PLA, transmission distance: 2
BambuLab Basic Green PLA, transmission distance: 4
BambuLab basic beige PLA, transmission distance: 8
BambuLab Basic Ivory White PLA, transmission distance: 5
This print uses six unique consumables.

Switching instructions:
Starting with black
Switch to red on the 8th layer
Switch to brown on the 12th layer
Switch to BambuLab Green on the 14th layer
Switch to beige on the 19th layer
Switch to jade white on the 22nd layer