This is a right-angle guide rail suitable for the DWE6423 sanding machine from DeWalt

I used to have a Festo ETS EC 150, and I found this clamp very convenient. So I decided to make one for the Dewalt sanding machine and always install it on it.

It was screwed together with an M5 screw and a nut. There was a bit of a problem with the strength around the nut. It would rotate, but I managed to hold it in place with a screwdriver and was able to tighten it. If I was going to remove it, I would use more layers or a higher packing density to solve this problem.