Made to replace the terribly designed and easily lost flexible button on Harbor Freight Gordon flashlight - Harbor Freight catalog #98506, or 63602. If you've purchased one, the button inevitable falls out and is easily lost.

This replacement is slightly larger and is meant to be printed with TPU filament, or any other flexible printing material. I printed it in a slow speed (30mm/sec) with 2mm retraction and no supports. Bed temp 55C, Extruder temp 230C.

Final output will have strings from the center button to the outer rim. Trim them away easily with small scissors or a sharp knife and you're good to go! No real post-processing needed other than the above.

Anycubic

All-metal Mega

No

No

200

38

Print at high quality - 0.1mm (prints in about 10 minutes)
Supports: None
Retraction: 2mm retraction or your favorite TPU setting.
Print speed: 30mm/sec
Skirt: 3 passes

Simply cut the strings with a small knife or small scissors. No need to remove them entirely. The button will move freely with the strings cut.