This is a 3D-printable model of an M8 barrel nut (aka cross dowel), in 17mm and 15mm lengths.

Printed at 100% infill without supports.

This part is intended for non-functional, cosmetic, or prototyping use only.

This part is not a substitute for a genuine metal M8 barrel nut.

Do not use this part in any application that is structural, load-bearing, or where failure could result in damage, injury, or a safety hazard.

The strength of this 3D-printed part is significantly lower than a standard metal component. It is highly susceptible to cracking, stripping, and breaking under any significant torque or tension.

Use at your own risk. The creator is not responsible for any damages or issues that may arise from using this 3D-printed model in a functional capacity.