I'm getting into APRS, and Byonics sells a LCD/Keyboard adapter that allows you to use theirTinyTrak4 to send and receive messages. No one has a case to hold the LCD, so I made one.

I'll be making changes or adding parts to this design, maybe a TinyTrak4 enclosure that will allow the cable coming out of the TT4 to look a bit better - right now you have to cut a hole in the TT4 case or, remove the case.

Version 1.0 - 1st release
Version 1.1 - Enlarged the cable feed hole, from 17mm to 20mm, this allows the 2x5 ribbon cable to pass through the hole a bit easier.

Still not able to upload pictures, sorry.

Creality

Ender 3

No

Yes

0.2

20

Print FACE DOWN, this way only two small supports are needed for the legs. I didn't use supports for the cable hole, however, you may need to depending on your printer.

Takes 7 or so hours to print at .20mm layer height, at 80mm/S