EasiYo Yoghurt maker replacement lid outer
FreeTab
Find Similar with AI
Print Profile(0)
Model File(0)
0
0
0
Published:2025-12-04 02:33:32
0
0
000Description
Model Source
Reviews(0)
My EasiYo yoghurt maker lid fractured due to heat and UV damage, so instead of going to a shop to buy a replacement (now in multiple colours!), "I make a new one".
This is a simple OpenSCAD hull() design which fits nicely on the original red inner part of the lid replacing the outer shell. There is a polystyrene disc insulating disc sandwiched in the middle, which was a bit snug so v2.0 has an extra 5mm of height.
The outer curves are gentle to allow printing without supports.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Infill:
Low for insulation
Notes:
Prints without supports upside down.
I used black PETG filament, as that's was in the Ender 3v2 printer. White perhaps would be better!How I Designed This
This is a simple OpenSCAD hull() design - three cylinders 'wrapped', then repeated slightly smaller to carve out the inner.
Model Source
Original Link: View details
CC-BY