I have a Hotone Ampero switch to change effects on my Line 6 HX One. When I added it to my pedalboard, I was annoyed by the fact that it set so low which made it difficult to hit the switches when I had other pedals near it. To solve that issue, I designed and printed this, slapped some velcro on the bottom, and put my Ampero switch into it which gets it up high enough to solve my problem.

I designed this to pressure fit and printed in PETG. The tolerances are TIGHT and it took a bit of force to get the switch into the riser. If you plan on using velcro or something else to mount your Ampero switch into this, I would print this a few percent larger (like maybe 104% or so). I also recommend using something stronger than PLA and using at least 50% infill since you'll be stomping on this.