My first design for 3D printing. I have a dish drying rack that had a bamboo block for holding knives as they dried. Eventually the moisture caused the block to break, so I printed a replacement.

I added a stop on the back of the block so that it doesn't slide into the other utensil areas of the rack.

If I were to modify it, I might make it a little thicker so it sits deeper in the tray. As is, it can start to tip out of the rack if you don't gently slide the knife in.

Print Settings

Printer Brand:

Bambulabs

Printer:

Rafts:

No

Supports:

Resolution:

.24

Infill:

Filament: Bambu Lab PLA Basic PLA Orange

Category: 3D Printing