I made this little and simple model to AFK my Nintendo Switch. It works on OLED, Normal, and Lite (although on the lite model, the use is more limited).

How To Use

All you have to do is slide it over a joy con button, detached or attached to the Switch. then, it will start holding down the button for you! You could also push the thinner side of the AFKer under a joystick, to hold it in a right or left position.

Print Settings

1. Infill: I recommend 90+
2. Supports: None
3. Adhesion: Optional
4. Material: I used PLA, but i would love to see other materials used

Any thing else is up to you! now all you have to do is… Juts_Printit!