About

I really liked the original Moon Phase Extruder Visualizer by @SconnieMakes and I initially created this remix because I wanted a circular shape for the base of the visualizer. While working on the model, I made a few additional QoL changes. 

The list of changes from the original model are listed below:

• Created a disk around the model to change the shape. 
• Removed the stars in the center of the model (the tolerances were too tight and I couldn't get them to fit without artificially widening the holes) 
• Added a new 1mm base in between the model and the actual base
• Added a 1.5mm base with an 8.5mm Ø cutout to fit an 8x3mm neodymium magnet.
   

Print Settings

0.15mm Layer Height

Supports Required
 

Assembly

Add a drop of superglue to the middle of the hole on the underside of the disk. The glue should flow around the magnet once you place it in. Let it fully cure and enjoy!