Interfaces with standard cubicle walls. I use a #4 S-Biener to hang a spare set of shoes up in my office.

I am not sure how much weight they will hold, but I have not broken one yet.

This one is 11.5-mm from the edge of the interface and the hole diameter is 12-mm. The body is offset by 45° from the cube wall interface. You can reflect the part with the cube wall interface to make one that will interface on the other wall in the corner.

Print out the two included pieces and glue them together. Print in ASA or ABS that can be easily glued together with solvent, or use cyanoacrylate glue for PETG or PLA.

Fill density and layer height are flexible. 0.35-mm at 50% seems to work great. No brim or support is required. Cube wall interface is angled at 45° so no support is required.