This is an iPad Mini Tabletop stand designed to hold iPad Mini at a slight reclined angle in landscape orientation. It may also work for full size iPads or other tablets as well (but I have not tested this.) Design is very strong but uses relatively little plastic due to structural girder-like design with fillets at intersections.
Easy to snap off supports are integrated into the design (they are not shown in the rendering above) to allow the horizontal beams to print in the air above the printing platform in both .thing and .STL files. Highly recommend using a raft if you are going to print directly from .STL.
Normal print settings were used in Makerware (rafts option checked, do not check the box to have Makerware add additional supports!) I did notice a slight drooping of the PLA material on the underside of the upper diagonal member located on the sides of the holder but the drooping is not really noticeable unless you turn the stand over. The drooping of material could be eliminated or reduced by printing at higher layer resolution settings.