I will upload later tonight with a better print and better pictures later tonight.

---

Ender 3 extruder filament guide which is made to work in conjunction with a filament guide arm such as https://www.thingiverse.com/thing:2917932.This uses a piece of filament tube about 3.5cm in length and is friction fit.

---

Sliced with Cura 4.4.0.

Line Height - 0.28
Line Width - 0.4

Wall Thickness - 1.2
Wall Line Count - 3
Top/Bottom Thickness - 1.04
Top Layers - 3
Bottom Layers - 3

Infill Density - 20%
Infill Pattern - Grid

Print Temperature - 205
Build Plate Temperature - 60

Build Plate Adhesion Type - None

Printed on a Creality Ender 3.

The filament used was Overture 1.75 PLA

---

Print Settings

Printer brand:
Creality

Printer:
Ender 3

Rafts:
No

Supports:
Yes, on bed only

Infill:
20%

Filament brand:
Overture

Filament material:
PLA

---

Feel free to leave comments and post your finished prints. Donations are always welcome, as a lot of this is trial and error as I test these designs.

Dogecoin address: DSfAqQ1mBXngnwPSXKJcRcockx51WDFFgK

Creality

Ender 3

No

Yes

20%