had these led lights that use 110v an decided to make a socket to hold them so i can put them inside my printers. u can straighten the pens on the light an the stick through the socket, i plan to add to this an make a 3 light circle that goes in the top of my delta printers but i figured id go ahead an share the socket since i got it working now. if u use it the way it is id run the wiring through the holes in the socket an solder them to the pins then cover in shrink wrap then put the light into the socket an all that will stick through then will be the wire an the cover pins. the first few i printed in a silk pla+ an i had to keep making changes to the model then i realized this filament was expanding so i went back to the first model i made an printed it with some sunlu pla an it worked perfect. it prints quick so use whatever settings suits ur needs, i printed it at .21 layer with 15% cubic infill on a flsun qq-s so .2 on a ender3 style printer is what id print it at in that case. but again its a simple model an simple to print so any settings should work no supports required.

Print Settings

Printer:

FLSUN QQ-S PRO

Rafts:

Supports:

No

Resolution:

Infill:

15

Filament:

sunlu pla

orange

Notes:

Category: DIY