Nothing fancy, just a basic laptop stand.

Was making it for a bunch of people so tried to make it:

• Use as little plastic as possible for faster prints
• Still be sturdy enough to never break
• Be large enough to never really tip over, but small enough to easily carry around

It came out well (the one in the pictures had a layer shift early but then soldiered on and finished fine) and is stronger than expected. Could probably make the triangle a bit smaller, but it would put more stress on the tail of the base, as well as possibly start putting stress on the bit that fits around the laptop.

Fits my 15" computer and could probably hold a decent amount larger.