A small parametric standoff for the new MagSafe charging pucks. The issue I have with the pucks is that their very strong magnets and they are very thin. These are desirable traits. However, this can make them hard to remove if you can't get you fingers under your phone to a good grip. This model aims to make that easier and go unnoticed. It adds a very small amount to the diameter and give you about 5.25mm extra finger room. 

I use some double sided tape to hold it in. The friction fit isn't bad but the magnet is stronger. 

I designed it to fit this particular MagSafe charger but it is parametric to allow others to easily tweak the design as they see fit. 

Print Details:

• 0.6mm nozzle
• Jessie PETG
• Textured Plate