This case for the Raspberry Pi 3 Model B. This model is not a remix, but it was influenced heavily by jayftee's model found at the link below. The main difference is that I made my case slightly larger to cover the USB ports, and gave the case a larger clearance to accommodate the Pi.

http://www.thingiverse.com/thing:1427797

I gave the Pi a 0.5mm clearance around most features. and made the vertical features separating the Ethernet and USB ports relatively short to allow an easy fit over the Pi.

This case is intended to be paired with four M2 x 0.4mm thread x 20mm long screws which are available at McMaster (Item# 91292A013). You may also find these parts at your local hardware store.

I printed the case using PLA at a 200 um layer height and a 0.5mm extrusion width.