Ender 3 Ring Light Mount
JonathanJolley
Find Similar with AI
Print Profile(0)
Model File(0)
0
0
0
Published:2026-04-08 22:50:21
0
0
000Description
Tags
Model Source
Reviews(0)
I designed this mount for this mini ring light that I won at one of those ticket arcades. I don't use it for my phone so I decided to repurpose as a light for my print bed. I designed this from scratch in Fusion 360.
I am not sure of the make/model of the ring light, but it seems to be generic. I found this one that looks just like the one I have.
If you make or remix this, please tag me as I would love to see it!
Find me on IG: JoeyMakesStuff
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.28
Infill:
50
Filament: Overture PLA Black
Notes:
Printed on PEI bed at 200/60 with a slightly modified CHEP Extra Fast 0.28 profile. I recommend normal supports and everywhere due to some of the angles. Even with supports and 50% infill, it should take less than an hour. The file should be in the correct orientation for printing.
Go slow removing the supports as its a small part. I did have to take a strip of sandpaper and sand where the USB connector slides into then clean with some isopropyl alcohol.
On the ring light, you will need to remove the clip pin, clip, and clip spring to install this mount. There was a small nub I had to snip and sand down where the clip spring slides out of.
While I did include an STL for a locking pin, I recommend using an M2 x 25mm screw
Category: 3D Printer AccessoriesTags
Model Source
Original Link: View details
CC-BY