Simple container with magnetic closure to store small objects such as screws, nuts or electronic components.

The magnets used are 4mm in diameter and 2mm high, subject with glue.

*V2: In version 2 I made the cavity for the magnets inside the model, under an upper layer of 0.2mm, so the best configuration would be to print it with a layer height of 0.2mm and to program a pause just before the last layer to place the magnets (taking care that the polarity is the same for all the magnets and in this way allow the lid to close in any position). -No glue is necessary. -Magnets not visible and projected

Print Settings

Printer Brand:

Creality

Printer:

**Rafts:**

No

Supports:

**Resolution:**

0.2

Infill:

**Filament:** . PLA

Category: Containers