***NOTE***

I will no longer update this design as I have remixed this design for a more long term use case. This is good for if you need to extend it temporarily or on occasion.

I recently picked up a larger size Garmin Edge computer, but I already had a great aluminum front mount that's too short to mount it. As I use the mount for other things from time to time, I didn't want to remove the existing garmin insert in the k-edge when changing devices.

This was quickly made, just so that I could mount my garmin for an indoor ride, but I will be working on it to refine the design later.

I printed it in PET-G intending it to be for indoors and outdoor rides, but did not have a chance to try it outside yet. Just make sure you have it tied to your bike with a lanyard in case it breaks.

UPDATE 12JAN2021

I created a slimmer design. You'll need to use supports everywhere or it'll not fit well.

UPDATE 30JAN2021

Rode this outside on bumpy roads and it didn't last. I think this would probably be best for temp purposes or indoor only as I would've lost my garmin it I didn't have the tether to prevent it from falling off.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.24

Infill:

Filament: Generic PET-G Transparent

Notes:

Category: Sport & Outdoors