I made these brackets to mount an aluminum rod for convenient wire spool storage underneath the shelves on my workbench. Each rod can hold 4-6 wire spools, depending on gauge.

Hardware

2x Printed Part

1/2" x 12" Aluminum Rod

M2.5 Assortment Kit

• 4x 10mm M2.5 Socket Head Cap Screw
• 4x M2.5 Hex Nut
• 4x M2.5 Washer

Stainless Steel Overshelf

Assembly

Put the washers in the countersunk holes on the inside diameter, then the hex nuts. Push the aluminum rod through the hole. Install the bolts from the outside, as you tighten them, they will thread through the hex nuts and push against the aluminum rod. Add your wire spools then install a second printed mount on the other end of the rod.

With my shelf, there are 24.5mm between the inside faces of the two printed parts. Adjust this spacing to fit.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Filament: AmazonBasics PLA Gray

Notes:

Category: DIY