This is designed to make a shelf in my kitchen closet which has a big hole in the bottom part

I can attach each piece with safety and without bending from joints when printing in 10mm thickness or more.

I used infill 20% and gyroid shaped infill pattern in Cura.

If you use less than 8mm thickness to print you will more likely to see movements at joints so please print with knowledge.

With 100% 4mm thick print I get 110 grams plate.

With 20% infill 10mm thick print with gyroid pattern I get 120g and a stronger one!

I also used a joint with wood screw to make my print more strong! You make a shelf for your taste!

I tested with PLA and Petg. Works fine.

I attached the fusion 360 file so you can make adjustments accordingly. Print and use with love.

Print Settings

Printer Brand:

Anet

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

200

Infill:

Filament:
Porima PLA Blue

Category: Organization