Summary

This is mostly a new design, but it is slightly based off the camera mount I use for my Nighthawk280. For it to mount well in the ET160 it gets printed in 2 pieces and then it gets sandwiched together inside the frame between the top plate and bottom plate.

The mount allows for about 12-50 degrees of tilt, finger adjustable between flights. The Sony camera it is intended to be used with is any of the plastic case compact Sony Super HAD cameras such as the "Foxeer XAT600M" from surveilazone.

IMPORTANT NOTE FOR THIS PART: Use of this mount requires that you add 2mm spacers between the top and bottom plates. This is to accommodate space for the camera to tilt down and up and not be touching the frame at all. The spacer is built into the X4rSB tray that I designed for the rear 2 bolts, For the front two, I just used some 2mm thick plastic cut down with a hole drilled through it. Also, you will likely have to trim down the interlocking nubs a touch for them to fit well.

I also made a VTX for the ET25/ET200 VTX and an X4rSB/D4rii RX tray that work well together since they share bolt down points. These other 2 parts will be online soon