Hi all, I was struggling for some time create a storage solution for all my Aeon's End games. I ordered some card storage solutions with slots for tokens (I can recommend some, if wanted), but couldn't find any sufficient storage solution for the mage and nemesis tiles/mats. So I created one! The box also has slots for two life dials; one nemesis and one Gravehold.

I currently have all mages and nemesis tiles of wave 1 to wave 5 (both base games as expensions, see Waves) in the box, except for Legacy (in the pictures, it only holds wave 1 to wave 4). 

The box uses a piece of filament as hinge, which works wonders. The box has cut-outs for 10x10x4 magnets (six in total, see notes, I used a drop of superglue to keep them in place while printing), which I ordered on Amazon. The six magnets are super strong, I can easily lift the whole box by holding the top only. This does tend to make the box a bit hard to open, so using less magnets might be advised (depending on your preference).

As you can see, I used white filament (PLA). While it looks neat (and fits my card storage boxes), you can actually see the magnets through the thin layer encapsulating them. See the fifth picture.

After printing the box, I ran into one rookie mistake, which I fixed in the attached models; the life dials won't fit in mine (or rather; they fit, but then the box can't close). I tried to make this clear in the last picture (again, this is fixed in the model files by removing the divider of the top).