Replace the locks on your US General Hanging Tool Cabinet with these large nut themed door pulls.  Print one of each part, then use an M5 screw (around 8mm works well, but there's room for longer) to bolt it through the hole left by removing the lock.  May fit other cabinets, but designed to be a snug fit in this cabinet:

https://www.harborfreight.com/hanging-tool-cabinet-39213.html

I prefer to print them face down with 0.28mm layers.  I use the bucket fill tool to fill the bottom of the bolt only with black and print the rest in silk silver PLA.  If your printer is dialed in and your filament is dry, the large bridging shouldn't be a problem.