I have acquired plenty of Transformers over the years and many are broken or missing parts. I'm new to 3d printing and just now learning Fusion 360.

My G1 Blaster part bot was missing some pieces so I decided to try and make some replacements.

This is the foot, left or right. I didn't want to break my original foot so I measured it still attached. The two that I printed were too tight so I had to sand the sides. The foot will go in easy, but may also pop out easy. The bottom is also flat, no lines like the original. I haven't learned how to add those yet. LOL but if that doesn't bother you, well here you go.

Creality

Ender 3

No

No

.2

90

Prints flat