Mount for a Camera that hangs off the 3D Fused X axis bar. Can be used with any camera that uses a "Popcorn ball", these are easily found on Thingiverse. - see http://www.thingiverse.com/thing:2000126 for an example.

Only takes 2 hours to print at .2mm layer height, 80mm/S with a .4mm nozzle. Uses 15 grams of filament, 5.51 meters long.

Creality

Ender 3

Doesn't Matter

Doesn't Matter

.20

Standard 20%

Print on it's side, then only a small support is needed.

Asked 3dFused.com for the screw spacing, and offered the STL's to them, they suggested I post them here for everyone to use.