Summary

Little box I made for DS4 controller for auth...

Based on JDM-055 but should work for any since JDM-040.

Screws:
PCB 2x3-4mm
USB 2x4-5mm
BOX 4x10mm

You need to remove both analogs and jack connector.

Removing the analogs will make them pull to one side, so replace each analog pot with:
2x10kOhm resistor (8 total)

(I believe you can just remove the analog housing and leave the pots centered and bend them so they can fit on the box...In my case I had stick pull even with good pots so I just went it replacing them with resistors.)

Depending on your DS4 version you may need or not a 3v source to fake the battery.
On JDM-055 I used a AMS1117 module.