This was designed for the D&D dice challenge! 

Dice tubes can hold up to 2 dice. Slot them into one of the middle holder's hexagonal holes and slap the end to shoot any dice out. 

To store and transport, first attach front cover to the side with circular holes then attach back cover to the side with hexagonal holes.  Use the handles in the middle section to carry/use as feet!

All models are pre-oriented, only the tube and middle holder with handles require supports. Tube can be printed with build-plate only supports.

Reach out if tolerances are too large/small, I tested them only using my printers

Settings:

10% infill

.15-.20mm

although using adaptive layer height can make the middle holder's handles turn out great!