Using the same skeleton architecture as the Buster Mech to speed up development, the Range Mech was deployed by Earth's forces to provide mid-long range fire support.

The Range Mech's arms were equipped with high powered energy casters that required the installation of a higher capacity but much heavier energy backpack. Armor on the torso and legs of the mech were redesigned to be lighter, but still relatively durable, to compensate for the extra weight added by the backpack. The head was upgraded with improved cameras as well as antennae that provide enhanced the mech's radar range and stability.

The Range Mech MK 2 was designed with a focus on simplicity, durability, and ease of printing.

Joints are achieved through a system of 3mm pins that give just enough friction while also easily removed with pliers (for maximum strength, print these so that the long side of the pin is parallel to the build plate).

3 millimeter ports on the arms, legs, and back allow for cross compatibility with most other model kit accessories.

I hope you enjoy. Please send feedback as I may create improved versions of the figure in the future.

Depending on your printer and plastic, some light sanding and/or tightening of parts may be required. Tightening may be done via thin layers of super glue or multi-surface floor polish.