A holder for two large (ø ~92mm ) shampoo and conditioner bottles to be squeezed onto two 12mm pipes.

When I finished the design I realized it would require a lot of support material to print but I had lost interest in this model at that point so I just printed it that way. Be aware of this if you are going to print it (see pictures)

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

I used adaptive, but 0.2 would work fine

Infill:

Notes:

Printed in white PLA, maybe not the most suitable for water but it has worked for 4 months now.

Post-Printing

I added some rubber (purple parts) to prevent sliding on the pipes. I also added some m3 threaded brass inserts in the back plate by heating them up with a soldering iron and pressing them into the holes from the back. I then stuck the back plate behind the pipes and screwed the holder body into the back plate.

Category: Bathroom