Figurine of Chroma from Warframe in agile pose.
Created based on GMod pre-rigged models with normal map de-baked and then other additional tweaks.

Successfully printed with Ender 3 at 0.2 layer height for time. Model was scaled to 10cm tall.
I would suggest extra caution when removing material around the knee loops. They detached when I removed the supports. Other than that, the model prints very nicely.

SUPPORTS REQUIRED

I would also suggest printing to around 15cm tall with 0.15 layer for a nice looking model.

Creality

Ender 3

No

Yes

Picture is 0.2mm, smaller works fine

20%

You should probably scale this to >10cm tall if printing with layers larger than 0.2mm as you just lose a lot of detail.